HITEC Aggressor SRX - Manual (Page 11)

This menu allows you to set up the initial settings of the model, and
will typically only be accessed once unless setting up a new model.
The main edit mode screens will appear in the following order:
1. Model Naming 2. Model Reset
3. Channel 3 switch set 4. Timer
6. Main Edit mode
B) Model Naming
- Note: Be aware that you have to select the model you wish to name in the
Programming mode first. (See Programming Mode [Model Select] to Select Desired Model)
- Press the "DATA" + or - buttons to Select the proper letter or symbol.
- Press the "SEL" (Select) button to move the curser.
- After the name is set, press the "FUNC" button to scroll to the next menu,
or turn the transmitter off and back on to use the radio.
- Access the programming menu by holding the "FUNC" (function) button down,
and then turning the transmitter power switch on. Release the function button.
- The model naming screen should appear.
Programming
A) Entering the Main Edit Mode
C) Model Reset
- After entering the Main Edit mode press the "FUNC" button to scroll to the Model Reset menu.
- To reset the model you are programming, press the "DATA" + and - buttons at the same time to
complete the reset procedure.
- If properly done you will hear two "beeps".
- Be aware that all the settings will be reset to factory default, so anything previously set will be lost.
- Press the "FUNC" button to scroll to the next menu, or turn the transmitter off and back on to use the radio.