HITEC Aggressor SRX User Manual

Page 12

E) Timer

- After entering the Main Edit mode press the "FUNC" button to scroll to the Timer menu.
- Press the "SEL" button to move the curser to select minutes. Time can be set from 01:00 up to 99:00 minutes.
- To activate the timer when using the radio, push the "SEL" button.
- To pause the timer, push the "SEL" button again; then, push it again to restart.
- To cancel the timer, push the "FUNC" button.
- Note: When the timer reaches 00:10 seconds, you will hear a beep for each second counting down

until it reaches 00:00.

- Press the "FUNC" button to scroll to the next menu, or turn the transmitter off and back on to use the radio.

F) Exit

- Once you have set all the parameters in this menu you can exit by simply turning the radio off,

and then back on again to operate.

- If there is still more programming needed push the "FUNC" button to scroll through the menu again.
- Scrolling only moves in one direction, so if you miss a screen, you must scroll through all of the

menus until you get back to the screen you want.

D) 3rd Channel Switch Select:

AUX

- After entering the Main Edit mode press the "FUNC" button to scroll to the 3rd Channel Switch Select menu.
- Push the "DATA" + and - buttons to Select either "Linear" or "Shift".
- Linear is activated via the trim tab on the right side of the steering column and can be moved to

any position you select. This is typically used for mixture control in nitro boats, but you can use it for
other functions if needed.

- Shift is activated by the momentary button located on the left of the steering wheel. This is used to

shift vehicles such as the T-Maxx or similar type vehicles.

- #Tip: Use the knuckle of your left thumb to push the button to shift. When the button is pushed the

AUX servo will travel to one end. When it is pushed again it will travel to the other end.

This travel can be set in the EPA screen in the programming mode for fine tuning.

- Press the "FUNC" button to scroll to the next menu, or turn the transmitter off and back on to use the radio.