HITEC Aggressor SRX - Manual (Page 13)

7. Programming mode
This programming menu allows you to access the settings that you would typically change to set up
your vehicle or change models. The Programming mode screens will appear in the following order:
1. Model Select
2. Sub-Trims
3. EPA
4. Exponential
5. Servo Reverse
Programming
- Access the menu by holding the "FUNC" (function) button down for
three seconds while the transmitter is already on.
A) Model Select
B) Sub-Trims
- After entering the Programming mode press the "FUNC" button to scroll to the Sub-Trim menu.
- ST "Steering" will appear first. Use the "DATA" + and - buttons to adjust the sub-trims right or left.
- Press the "SEL" button to access the TR "throttle" sub-trim and adjust with the "DATA" + or - buttons to
adjust the sub-trims forward or back.
- Press the "SEL" button to access the AUX "Auxiliary" 3rd channel sub-trim and
adjust with the "DATA" + or - buttons to adjust the sub-trims right or left.
- Note: Push the "DATA" + & - buttons at the same time to reset to factory default.
- Press the "FUNC" button to scroll to the next menu, or press the "FUNC" button for
three seconds to return to the operation screen.
- Press the "DATA" + or - buttons to Select the model to be used. (1-10)
- Note: Be aware that if you wish to name or re-name a model, you will need to turn the radio off,
and then follow the model naming instructions in the main edit mode.
- Press the "FUNC" button to scroll to the next menu, or press the "FUNC" button for
three seconds to return to the operation screen.
TH
AUX
S-TRIM
ST
S-TRIM S-TRIM
MDL