Hatteland Display HT 221 (2U Size) - Manual (Page 18)

18
General Installation Recommendations
Installation
IND100210-17
Mounting Rails Kit Accessories
Hatteland Display offer two types of sliding rails depending on installation needs, both 19 inch Rack Compatible.
- HT 00224 OPT-A1: 2 x 20 inch long ball bearing sliding rails.
- HT 00225 OPT-A1: 2 x 26 inch long ball bearing sliding rails.
These are not included with standard delivery, both variants must be ordered separately, for more information:
http://www.hatteland-display.com/accessory_ht00224opt-a1.php
http://www.hatteland-display.com/accessory_ht00225opt-a1.php
Note: Review 3rd party mounting instructions found in the Sliding Rails package, a brief introduction shown below:
1: The 3rd party sliding rails shown below. The 2U
cabinet supports both 20” or 26” sizes depending
on option chosen.
2: Mount the sliding rails on each side of the 2U cabinet.
Fasten it with 4 screws (included) as indicated onto
chassis mounting holes. Make sure you use the
supplied screws in the package.