Hanna Instruments HI 222 - Manual (Page 24)

24
SERIAL COMMUNICATION BAUD RATE SET
Press the CAL key when the baud rate is displayed. The baud rate (600,
1200, 2400, 4800 or 9600) will begin to blink.
Press the ARROW keys to change the baud rate.
Press the CFM key to save the modified baud rate or press the CAL key to
cancel without saving the baud rate.
SERIAL COMMUNICATION COMMAND PREFIX SET
Press the CAL key when the command prefix is displayed. The command prefix
(0 to 47) will begin to blink.
Press the ARROW keys to change the command prefix.
Press the CFM key to save the modified command prefix value or press the CAL
key to cancel without saving the command prefix.
Note: See the PC Interface section on page 28 for a complete explanation. The
command prefix must be 16 if the HI 92000 PC software is used.