Hall Research SC-VD-2 - Manual (Page 8)

Model SC-VD-2
6
3. Configuration & Operation
3.1 Front and Rear Panels
3.2 Menus and Adjustments
Pressing the Menu button will bring up the OSD menu controls on the
screen as follows:
¾ Input set up
¾ Output set up
¾ Picture Adjust
¾ HV Adjust
¾ OSD Adjust
¾ System Information
¾ Auto Adjust
¾ Exit
Use + or - to move the arrow cursor to your desired selection, then press
MENU to confirm your selection and enter into that sub menu.
I I n n p p u u t t s s e e t t u u p p - -
When selected, a sub menu of clock, phase, and input
mode is shown.
YPBPR …
9
RGB
Use + or - to choose the parameter your want to adjust and then press Menu
(Enter) to highlight your selection. Once a parameter is high-lighted use +
or - to increase or decrease the setting value. Press Menu (Enter) again to
leave the setting. Move the arrow to exit then press Menu/Enter to Exit.
Clock: Used to adjust for optimal input clock frequency for a stable picture.
Pressing + narrows the width of the picture toward the left. Pressing -
extends the width of the picture toward the right.