beautypg.com

Hall Research VSM-I-A-16-16 User Manual

Page 37

background image

35

Genesis™ Matrix Switches

Port 1001 by default is used to control the matrix (this port number can be
changed as part of the IP Settings). The commands used to control the matrix are
the same as those through the RS-232 Serial port.

3.2.14.1 IP Setup Commands using the RS-232 Serial Port
IP interface on the matrix has a unique MAC-address, and it must be assigned a
valid IP-address to function properly on the network. As shipped from factory this
IP is 192.168.123.180

1.

To get into the IP setting mode:

Note:

Inactivity period of 16 seconds causes the system to exit this mode. You can also hit

ESC to end the IP setting mode.

Command:

IP stands for IP setting mode

Response:

Enter IP commands:
This is the normal response meaning that IP setting through the RS-232 port is
allowed

- - - - - Alternate Response - - - - -

IP commands not enabled. Please refer to the manual
This message indicates that IP setting through the RS-232 port is disabled on
your unit for some reason. Please refer to section 3.2.12.2 below to enable this
mode

2.

To get the current IP address of the matrix box:

Command:

GIP stands for Get IP address.

Response:

192.168.123.180

3.

To set a new IP address:

Command:

SIP192.168.123.179 stands for Set IP address.

Response:

OK .................................................. if command completed successfully.
Error........................................................................... if command failed.

4.

To get the current gateway IP address:

Command:

GGI stands for Get Gateway IP address.

Response:

192.168.123.122

5.

To set a new gateway IP address:

Command:

SGI192.168.123.125 stands for Set Gateway IP address.

Response:

This manual is related to the following products: