Hall Research UHBX-S-PSE - Manual (Page 7)

UHBX-Series
7
one device. A separately sold adhesive rubber cover can be used to confine
the IR beam to just one target device. The CIR-EMT2 is placed in a cavity in
the cover and stuck on the target device directly over its IR sensor. A typical
application scenario is when several identical video sources are located in
close proximity to each other and they need to be independently controlled.
The CIR-EMT2 has a mono-type plug. Pin
out: Tip=Anode, Sleeve=Cathode
Figure 7 –
Alternate IR Emitter Cable CIR-EMT2
Figure 8 –
Emitter Cover: CIR-EMT2-CVR
(shown with CIR-EMT2)
4.2.3 Power Connection
The senders with -PSE suffix have a power input jack, whereas the -PD
senders do not (they get power through CAT6 cable). The -PSE Sender has a
+5vDC power input connector. The power input is over-voltage protected
and reduces the chance of damage if a wrong supply is accidentally plugged
in. As shipped the package includes a universal power supply with 5vDC
@3.2A output.
Figure 9 –
Power Supply
Model: 511-PS5032A
(shown next to pen for reference)