Hall Research UHBX-S-PSE - Manual (Page 4)

HDMI Extender with Power, IR, and RS-232
4
Full-duplex RS232 Serial Port extension is provided that can operate at any
baud rate to 115,200 (independent of video activity). The extender can also
extend IR from one end to the other. IR Detector and IR Emitter cables are
sold separately. The IR extension preserves the modulation (carrier)
frequency and provides compatibility to virtually any standard. It supports
modulation range from 30 KHz to 60 KHz
2.0 Features
• Extends HDMI or DVI video to 500 ft on just one Cat6
• Includes RS232 and IR extension in both directions
• Supports virtually all HDMI and DVI resolutions including 4Kx2K
• Only one end requires power, other side is powered via UTP
• Power-over-HDBaseT meets IEEE 802.3af standard
• Sturdy metal enclosures with mounting provisions
• Complies fully with HDBaseT standard
• Runs from just one +5vDC supply
• RS232 Supports all baud rates regardless of presence of video
• IR extension is carrier frequency agnostic and supports 30 KHz to
60 KHz modulation to provide compatibility across all IR standards
• Fully isolates ground between TX and RX sides
• Compact, Rugged, Reliable, and Economical
• Made in USA
3.0 Model numbers covered in this User’s Manual
Individual Ends
UHBX-S-PSE HDMI+RS232+IR+PoH UTP Sender with Power Supply (PSE)
UHBX-S-PD HDMI+RS232+IR+PoH UTP Sender Remotely Powered (PD)
UHBX-R-PSE HDMI+RS232+IR+PoH UTP Receiver with Power Supply (PSE)
UHBX-R-PD HDMI+RS232+IR+PoH UTP Receiver Remotely Powered (PD)
Kits
UHBX-P1 HDMI+RS232+IR+PoH UTP Extender, Sender (PSE) powers Receiver (PD)
UHBX-P2 HDMI+RS232+IR+PoH UTP Extender, Receiver (PSE) powers Sender (PD)