Hall Research UHBX-8X - Manual (Page 5)

UHBX-8X
5
3.2.2 Extender Serial Data Connection
Figure 5 – RS232 Port
If required, plug a DB9 RS232 cable from any serial control device to the
connector on the box. The RS232 port provides a bi-directional serial
communication with any compatible receiver. This RS232 port operates at a
fixed 19200 baud, 8-bit, no parity, and 1-stop bit. However, it can
communicate with any compatible receiver at any user defined baud rate.
Typically a straight-through male-to-female cable is used to connect to the
extender. Pinout of the RS232 connector on the sender is shown below
DB9-F Pin Term Direction
2 TX Output
3 RX Input
5 GND
Figure 6 – RS-232 path from UHBX-8X to remote receivers
3.2.3 Extender IP Connection
Figure 5 – IP Port
The RJ45 connector is a 10/100 Base-T Ethernet port. This IP port can be
accessed via Telnet. As shipped, the IP address is configured for DHCP
(assigned by your network’s router) and Port 6324 is used for Telnet
communications. Telnet commands are the same as RS232 commands.