Hall Research HR-731-S - Manual (Page 7)

HDMI and Serial over Single Fiber
5
Figure 3
SC Fiber Connector
5.1 Required Cables
• 1 HDMI cable to connect an HDMI source to the HR-731-S
• HDMI cable to connect the HR-733-R to the HDMI display
• RS-232 DB9 male-to-female (straight-through) cable to connect the
HR-731-S’s serial port to a PC
• Multi-mode (OM2 or OM3) fiber-optic cable
5.2 Fiber Optic Cable Requirements
Both the Sender HR-731-S and the Receiver HR-
733-R use a single SC connector and require a
multi-mode fiber-optic cable. The extender is not
compatible with single-mode cables. Multi-mode
cables are generally available in OM1, OM2, or
OM3 constructions. The OM3 cables are best
suited for max transmission lengths and are recommended for this product.
Data Rate OM1
(62.5/125 µm )
OM2
(50/125 µm )
OM3
(50/125 µm )
1.65 Gb/s
(HDMI 1.2a)
250 m (820 ft) 500 m (1640 ft) 1000 m (3280 ft)
3.4 Gb/s
(HDMI 1.3, 1.4)
150 m (500 ft) 250 m (820 ft) 500 m (1640 ft)
The above table shows the maximum possible cable lengths based on data rates
for 1080p resolution with normal 8-bit color, as well as 16 bit deep color per
HDMI 1.3 or 1.4, for different cable constructions.
5.3 Status of LED Indicators
LINK: ON – Optical link has been established between the sender and the receiver.
OFF – Optical link has not been established between the sender and the receiver.
VIDEO: ON – There is TMDS clock (digital video is coming from Source)
OFF – Source is not outputting digital video.
CEC: ON – CEC mode is on. OFF – Not in CEC mode.
RS232: ON – RS-232 mode is on. OFF – Not in RS-232 mode.