Generalmusic GRP-800 - Manual (Page 10)

Page6
owner's manual rp800
Page7
owner's manual rp800
DATA
BALANCE
DATA
BALANCE
EFX: Selecting an effect in a preset
Each of the Rp 800 presets can include an EFX. The effect type selection is notified by the corresponding
led on the panel. Press the EFX button to change the effect.
The preset PIANO1
has the effect OFF
(all leds are off).
Edit the effect send value for a selected preset
It is possible to customize the default effect level set
from the factory. Keep the EFX button pressed for more
than two seconds. The section leds start flashing
The display enters the effect send edit mode showing:
At this point press the BALANCE/DATA button >. The
first time you press the button the display shows the
current send level value, the next time you press the
buttons the value is modified.
Using a LAYER or SPLIT mode sound, is it possible to
change the effect sends for any of the enabled sections.
Enter in effect send edit mode.
Press the SELECT/TEMPO button >, the display
switches to the layer section
The editing procedure is the same as in the main
sound section.
Pressing again the SELECT/TEMPO button >, the
display switches to the split section
In this way the effect send of the split section can be
properly fitted.
Increase Increase Increase Decrease
value