FeiYu Tech FY-30A - Manual (Page 10)

Guilin Feiyu Electronic Technology Co., Ltd.
Guilin Feiyu Electronic Technology Co., Ltd http://www.feiyudz.cn [email protected]
- 9 -
The knob for Y3-copter
FY-30A Module Installation
1. FY-30A has an arrow indicator on top. Please ensure this arrow is pointed towards
the direction of flight.
2. Installed the module horizontally, and as close as possible to the aircraft center. A
more centered installation will result in more stable drift free of hover.
3. The FY-30A sets its own benchmark of what is ‘horizontal’. Install the module
based on the hover characteristics of the aircraft in Mode 1 (Stabilized Mode).
Shimming the module may be required to get the aircraft to hover perfectly.
4. You may also fine tune the stability of your aircraft using your radio Aileron,
Elevator and Rudder trims to counter any drift.
VIBRATION DAMPING
a) The FY-30A flight controller algorithms can filter and operate under normal
vibration levels, however if the vibration and shock experienced by the
onboard sensors is too big, stabilization can fail and the system can shut down
altogether.
b) Because of this, to achieve the best stabilization and flight performance out of
The ELE and AIL for the pitch and roll
sensitivity,turning the knob to the left will reduce the
gyro gain ,turning to the right increase the gyro gain.
The RUD for the yaw servo sensitivity,The gyro gain
is lowest when the knob in the middle. i.e. The
further away from center, the higher the gyro gain.
Turning the knob left or right off-center will change
servo direction for stabilization.
0 Min
100 Max
0 Min