FeiYu Tech Panda Autopilot - Manual (Page 33)

Guilin Feiyu Electronic Technology Co., Ltd
Guilin Feiyu Electronic Technology Co., Ltd http://www.feiyudz.cn [email protected]
Page 32
Parameters setting interface includes ―PID parameters ‖,―Control parameters‖, ―Flight
parameters‖，―other‖.
Flight Parameter Setting:
1. Auto photo: Enable automatic photography function.(can set Equidistance or Timing taking
photo )
2. Photo: Captures a photo immediately.
3. AP working mode Switch: Select if Shield the operation of the remote control (the default is
operate by the remote controller, in normal you not need to switch).
4. Loop path: This will repeat the current waypoints path (only works in the path navigation
mode)
5. RC datalink Switch: Select to use the data radio control or the RC receiver remote
control(the default is data radio control).
6. Parachute: Opens aircraft parachute (if applicable).
7. RTH Activated: Set the autopilot auto enter the Auto Return To Home mode(RTH) when it
detects communication interruption lasting 10seconds or more.
8. RTH Deactivated: Set the autopilot DOES NOT enter the Auto Return To Home mode(RTH)
even it detects communication interruption.
9. Auto landing: Enter the auto land procedure.
10. Cancel auto landing: Cancel run the auto land procedure.