Exo Terra Cascade - Manual (Page 3)

4
open water reservoir converting the terrarium in to a paludarium
or aqua-terrarium. You can also create a stand-alone waterfall
or cascade which recirculates the water from a water reservoir
or pond embedded in the terrariums substrate layer. The extra
large filter capacity and the 3-stage filtration system ensure an
optimal water filtration. Three separate filter cartridges guarantee
mechanical, chemical and biological filtration while allowing
alternate replacement for continuous biological filter activity. The Exo
Terra ® Cascade’s low voltage pump ensures safety when used in a
wet environment.
Read instructions thoroughly prior to installation and operation.
INSTRUCTIONS PERTAINING TO A RISK OF FIRE, ELECTRIC SHOCK,
OR INJURY TO PERSONS
IMPORTANT SAFETY INSTRUCTIONS
WARNING: To guard against injury, basic safety precautions
should be observed when handling the Exo Terra ® Cascade High
Performance Pump HP180, including the following:
WARNING: This appliance may be supplied with a polarized plug.
(one blade is wider than the other). As a safety feature, this plug will
fit in a polarized socket only one way. If the plug does not fit fully in
the socket, reverse the plug. If it still does not fit, contact a qualified
electrician. Never use with an extension cord unless plug can be fully
inserted. Do not attempt to defeat this safety feature.
Contains a cULus listed AC adaptor.
1. READ AND FOLLOW ALL SAFETY INSTRUCTIONS
and all important notices on the appliance before using. Failure
to do so may result in an unsafe condition or damage to the unit.
2. DANGER - To avoid possible electric shock, special care should
be taken since water is employed in the use of this equipment.
Do not attempt repairs yourself; return the appliance to an
authorized service facility for service or discard the appliance.
NOTE: the impeller and impeller-well must be cleaned as part
of regular maintenance.
A. For INDOOR HOUSEHOLD USE ONLY, NOT for commercial use.
For use with FRESHWATER only.
B. Do not operate any appliance if it has a damaged cord or plug,
or if it is malfunctioning or if it is dropped or damaged in any
manner. The power cord of this appliance cannot be replaced;
if the cord is damaged, the appliance should be discarded.
Never cut the cord.
C. To avoid the possibility of the
appliance plug or electrical socket
getting wet, position the unit to one
side of a wall mounted socket to
prevent water from dripping onto the
socket or plug. A “drip-loop” should be
arranged. The “driploop” is that part of
the cord below the level of the socket,
or the connector if an extension
cord is used, to prevent water from
traveling along the cord and coming
into contact with the socket. If the plug
or socket does get wet, DO NOT unplug the cord. Disconnect the
fuse or circuit breaker that supplies power to the appliance. Then
unplug and examine for the presence of water in the socket.
3. This appliance is not intended for use by persons (including
children) with reduced physical sensory or mental capabilities, or
lack of experience or knowledge, unless a person responsible for
their safety has given them supervision or instruction concerning
use of the appliance. Children should be supervised to ensure
that they do not play with the appliance.
4. Always unplug an appliance from a socket when not in use,
before putting on or taking off parts, and before cleaning. Never
yank cord to pull plug from socket. Grasp the plug and pull
to disconnect.
5. To avoid injury do not contact moving parts or hot parts such as
heaters, impellers, lamp bulbs and the like.
6. Do not use this appliance for other than its intended use (i.e. do
not use in swimming pools, garden ponds, bathrooms or any
situations where people are immersed). The use of attachments
not recommended or sold by the manufacturer of the appliance
may cause an unsafe condition.
7. Do not install or store the appliance where it will be exposed to
the weather or to temperatures below freezing.
8. Make sure an appliance is securely installed before operating it.
9. Read and observe all the important notices on the appliance.
10. If an extension cord is necessary, a cord with a proper rating
should be used. A cord rated for less amperes or watts than the
appliance rating may overheat. Care should be taken to arrange
the cord so that it will not be tripped over or pulled.
11. The pump must be immersed in water (maximum water
temperature 35 ° C / 95 ° F). The pump must not run dry.
12. It is suggested that this appliance and any other submersed
appliance be equipped with a leakage circuit breaker.
SAVE THESE INSTRUCTIONS FOR FUTURE REFERENCE
Only close adherence to these installation, electrical and
maintenance guidelines will ensure the safe and efficient use of
this appliance.
CAUTION
1. The Exo Terra ® Cascade High Performance Pump is for indoor,
household use only, and for use with water not exceeding
35 ° C / 95 ° F. This pump with filter is not recommended or designed
for use with corrosive or flammable compounds or liquids with
different properties other than water. The motor is hermetically
sealed to ensure safety and a long lasting life with all live
electrical parts immersed in a protective casing to prevent total
insulation against water damage and electrical shock. Since it
does not employ older technologies requiring oil cooling, it can
never leak or contaminate the area with coolant.
2. Be sure that the voltage of the mains supply corresponds to the
voltage shown on the rating label of the unit.
3. Before connecting to the mains supply ensure that the cord and
the unit are undamaged.
Installation
The Cascade high performance pump can be installed either
vertically or horizontally depending upon the preferred usage
application as long as the pump is completely immersed (example:
in terrariums, because of low water levels, the filter pump would
ENGLISH
FRANÇAIS
ESP
AÑOL