EXFO MaxTester MAX-610 - Manual (Page 74)

Setting Up Copper Tests
66 MAX-610
Application Settings

Label Customization
Connection lists the type of cable connection: T-R-G or A-B-E.

Test Parameters Preset

Power Line Frequency lists the frequency value of the power line.

Termination Impedance lists the values for the impedance of the
dummy load connected to the line.
When FED is Enabled on the FED Setup page, the termination
resistance of the FED is the same as the MaxTester except when
Standard is set to ITU, the termination resistance of the FED will
remain at 120
Ω since it does not support 135 ohm termination.

Noise Filter lists the type of noise filters to use.
To select the parameter values:
1. Press the up/down arrow keys to highlight the desired parameter.
2. Press the left/right arrow keys to view and select the options.
OR
3. Press on a value to open a list box of options.
4. Press to confirm the value.