EXFO MaxTester MAX-610 - Manual (Page 102)

Multimeter Tests
94 MAX-610
Voltage
Voltage
The Voltage test detects AC RMS and DC voltages in the line and allows you
to measure AC/DC voltages and Frequency on A/B/E or T/R/G depending
on the selected Standard in Setup/Application Settings.
Snapshot
The voltage Snapshot shows measured volts for each
lead combination. The parameters are as follow:

Current Group is the current test group name, for
example Multimeter.

Current Test displays the test being measured.
Here you can switch to another test from the given
list. However, this action will terminate the
ongoing measurement test.

Selected Pair allows you to select All Pairs or a
single wire pair for measurement.

Termination Resistance defines how much
resistance the tester uses to connect to the line and measure voltages.

Threshold Settings button opens a new page that allows you to set the
AC/DC voltage thresholds for each pair.

Result displays a snapshot of the pass/fail status, volts and frequency
(Hz) values for each continuous AC/DC pair.

Test Status displays the current state of measurement or an error
message.