EXFO ETS-1000L - Manual (Page 23)

Remote Management
Ethernet Tester Analyzer 17
Remote management commands (Telnet) - configuration mode
Note: Configuration mode commands become effective after save and reboot
commands.
Command Operation
ip address set interface IP address
ip netmask set interface subnet mask
ip gateway set gateway IP address
gbe mac set interface MAC address
gbe speed set interface speed:
10/100/1000/automatic
gbe autonegotiation set autonegotiation mode:
on/off
oam set OAM mode:
off/active/passive
vlan mode set vlan mode: on/off
vlan id set vlan identifier (a number in
the 0–4095 range)
vlan priority set vlan priority (a number in
the 0–7 range)
tftp enable or disable TFTP server:
on/off
password change admin’s password
save save settings; settings will be
applied after unit reboot
reboot reboot unit
exit leave configuration mode
help list of accessible commands