ENMET EX-2000 User Manual
Page 10
ENMET Corporation
EX2000
6
3.1.2 Scrolling of Parameters
To view the present status of MIN, MAX and battery level press the
BACKLIGHT
switch twice.
Example of parameter sequence:
Display
Sequence
Audio and Visual alarms are active during this sequence:
3 arrowhead symbols indicate instrument is not in measurement display mode.
1.
The Minimum (lowest) measurement detected since the
EX-2000
was
started-up or reinitialized (see section 3.1.4)
2.
Press the
BACKLIGHT
switch again.
3.
The Maximum (highest) measurement detected since the
EX-2000
was
started-up or reinitialized (see section 3.1.4)
4.
Press the
BACKLIGHT
switch again.
5.
Battery status is indicated with a series of bars. The number of bars
indicating the battery life remaining.
6.
Press the
BACKLIGHT
switch again.
7.
Return to Operational measurement display.
And Audio & Visual Alarms go to the normal mode.
3.1.3 Backlight
To backlight the
EX-2000
display for viewing in a low light location, press and release the
BACKLIGHT
switch.
The two red LEDs on ether side of the display will stay lit for 20 seconds.
3.1.4 Reinitialize Min & Max
The Minimum and Maximum readings are held in memory since the instrument was turned on. They are reset each time the
instrument is turned on. These measurements can be reinitialized (reset) manually (without restarting the instrument).
To reinitialize the
EX-2000
press and hold the
BACKLIGHT
and
ALARM
switches at the same time:
1.
The
EX-2000
will beep to indicate the min & max value reset is complete.
2.
Release the switches.
3.
The new MIN and MAX readings now equal the current value.
▲
▲
▲
BAT