ENMET SPECTRUM SP - Manual (Page 3)

SPECTRUM SP Series ENMET Corporation
1
1.0 Introduction
The SPECTRUM SP is a small portable battery operated single channel gas detection instrument featuring an internal
motorized sample pump. Depending on the sensor supplied with the instrument, it can detect one of a number of potential target
gases. An electrochemical cell detects the gas, and the gas concentration is displayed on an LCD. Audio and visual alarms
occur when the target gas concentration exceeds a preset alarm point or when air flow to the sensor is interrupted. At relatively
low concentrations of the gas, an alarm can be acknowledged, which results in the temporary cessation of the audio alarm.
Operation and maintenance procedures are managed with three pushbutton switches. Appropriate warnings are issued when
remaining battery energy is low. The instrument is shown in Figure 1.
Several sensors have been qualified for target gases, the list is found in Table 1 Appendix A.
N OTE : All specifications stated in this manual may change without notice.
1.1 Unpack
Unpack the SPECTRUM SP and examine it for shipping damage. If such damage is observed, notify both ENMET customer
service personnel and the commercial carrier involved immediately.
Regarding Damaged Shipments
N OTE : It is your responsibility to follow these instructions. If they are not followed, the carrier will not honor
any claims for damage.
This shipment was carefully inspected, verified and properly packaged at our company and delivered to the carrier in
good condition.
When it was picked up by the carrier at ENMET , it legally became your company’s property.
If your shipment arrives damaged:
•
Keep the items, packing material, and carton “As Is.” Within 5 days of receipt, notify the carrier’s local office and
request immediate inspection of the carton and the contents.
•
After the inspection and after you have received written acknowledgment of the damage from the carrier, contact
ENMET Customer Service for return authorization and further instructions. Have your Purchase Order and Sales
Order numbers available.
ENMET either repairs or replaces damaged equipment and invoices the carrier to the extent of the liability coverage,
usually $100.00. Repair or replacement charges above that value are your company’s responsibility.
The shipping company may offer optional insurance coverage. ENMET only insures shipments with the shipping
company when asked to do so in writing by our customer. If you need your shipments insured, please forward a written
request to
ENMET Customer Service.
Regarding Shortages
If there are any shortages or questions regarding this shipment, please notify ENMET Customer Service within 5 days of
receipt at the following address:
ENMET Corporation
680 Fairfield Court
Ann Arbor, MI 48108
734-761-1270 734-761-3220 Fax
1.1.1 Check Order
Check, the contents of the shipment against the purchase order. Verify that the SPECTRUM SP is received as ordered. Each
SPECTRUM SP is labeled with its target gas. If there are accessories on the order, ascertain that they are present. Check the
contents of calibration kits. Notify ENMET customer service personnel of any discrepancy immediately.
1.1.2 Serial Numbers
Each SPECTRUM SP is serialized. These numbers are on tags on the equipment and are on record in an ENMET database.