ENMET SPECTRUM SP - Manual (Page 13)

SPECTRUM SP Series ENMET Corporation
11
3.2.2 Battery Removal and Replacement
The battery is located under the circuit board.
To replace the battery:
Press on the locking tab and pull on the battery pack connector.
Remove the circuit board and then remove the battery pack.
Note that the battery pack is firmly attached to the enclosure with industrial strength adhesive tape.
Replace the battery pack and circuit board.
Reconnect battery pack connector.
Figure 5: SPECTRUM SP Series Battery Location
Internal View- Cover & Circuit board
Removed
Sensor Chamber
Pump
Battery Pack
T
H
IS
S
ID
E
U
P
Battery Pack
Connector
Internal View- Cover Removed
Sensor Chamber
Pump
Circuit Board
Pump Connector
Battery Pack Connector