ENMET RECON-IS - Manual (Page 6)

RECON-IS ENMET
4
3.0 RECON-IS Operation
3.1 Turn On RECON-IS
Press and hold the button for 3 seconds, the detector will turn on. After this, the detector will start a following self test:
Example: RECON-IS CO
A. Display all the fields and graphs and light the backlight.
B. The buzzer gives sound.
C. The vibration and alarm indication pulse.
D. Display the version number:
E. Display the preset low alarming value and the high alarming value:
F. Display STEL and TWA levels:
G. Warm-up Completion:
After passing the self test, the detector starts warm-up, display shows 3, 2, 1. The unit is now operational and
mentoring for the target gas concentration in the area:
If the self test fails, the RECON-IS will turn off automatically. Please contact the ENMET for information.
3.2 Turn Off RECON-IS
In the normal monitoring status, hold the button till the buzzer gives sound 3 times and the screen displays “OFF”, “OFF3”,
“OFF2” and “OFF1” as shown in the following pictures:
After that, the screen is off. Release the button and the detector will be power off.