Using winscope’s full capabilities, Turning on your microphone – Elenco PK101 w/ Computer Interface User Manual

Page 6

Using Winscope’s full capabilities:

Winscope has 2 input channels that can be displayed at the same time. This is commonly done by
electronic engineers using an oscilloscope, to show the relationship of one (or more) signals to
another. However use of this requires a second microphone input, which most computers do not
have. If the sound card in your computer has this then you may use all of Winscope features for 2
channels, which include X-Y and correlate modes. Use of these Winscope capabilities is beyond
the introductory level of this product, use the Help menu in Winscope for information about using
these features.

If you have any questions contact:

Elenco Electronics, Inc.

150 W. Carpenter Avenue

Wheeling, IL 60090

(847) 541-3800

http://www.elenco.com

e-mail: [email protected]

-6-

Turning On Your Microphone

(For Windows 98, other Windows versions may be slightly different.)

If you don’t get any signal from the PC-interface cable then your microphone may be disabled on
your computer. To turn it on, follow these instructions which begin by pressing the button
on the lower-left corner:

1. Select - - - (or ) - Control>.
2. Select .
3. Select .
4. Select in the “Adjust Volume For” box.
5. In the “Show the Following Controls” box, check .
6. Select .
7. In the “Microphone - Volume” box, check