Gk013 p04_05, Tumbling robot, Let's assemble "co-bot – Elenco Tumbling Robot User Manual
Page 3: Let's play with "co-bot, Fall, get up and fall again, Amazing and amusing walk, Caution

Head
Hip assembly
Legs (Left and Right)
Left
Right
Arms
Decals
Leg
Sensor
3 pins
Back
Chest
Sole of feet
LET'S ASSEMBLE "CO-BOT"
Parts list
Right Leg Assembly
left Leg Assembly (This is "Let 'Go Mode" in page 9)
Turn the gear in the hip so
the peg is positioned down.
01
Slightly lift the top gear and
hook the leg hole on the peg.
03
Line up the holes as
shown in the picture.
01
line up the left leg hole and
bottom hole of the gear as
shown in the picture.
02
Push a pin
firmly in until
it stops.
03
Line up the lower hole of
the hip assembly and the
elongated leg hole and
insert a pin.
04
Move the leg carefully over the
hip hook and bring the leg down.
04
Line up the lower hole of the hip
assembly and the elongated leg
hole. Insert a pin into the two
holes so two parts are joined.
05
Amazing Actions with a single motor!
Brilliant work of gears and cranks!"
Insert right leg from side slit.
Please purchase 2 AA
batteries separately.
Alkaline batteries are
recommended due to
their weights.
02
Complete
• Follow the instruction manual for assembly and operation of this product for the safety.
• Be cautious with small parts. They are choke hazards.
• Handle sharp corners and pointy parts with caution.
• Do not leave the product on the floor. Injury can occur by stepping on it.
• Do not coil the wires on body parts. This may cause injury.
• Do not touch the gears during the operation. This may cause injury.
• Do not experiment in the road.
• Do not experiment near river or pond.
• Do not experiment outdoor in the evening. It is dangerous due to poor visibility.
• Hard tugging and over stretching of the electrical wires may damage the wire.
• Pulling the arms and legs of the robot in the wrong direction may damage the product.
• Forcing to stop the movement of the robot by hand during the operation may damage the
product and/or cause injury.
• Do not disassemble the robot by unscrewing. It may damage the product.
• Do not use the damaged and deformed parts.
• Store away from toddlers' reach after completing the experiment.
Please read before assembling this product (adults/supervisors must read)
CAUTION!
* Recycle and dispose according local regulation.
* The photo images of the product may vary slightly from
the actual product in colors and/or small details.
Handle with caution! Two legs
are attached by a lead wire.
gear
peg
hip hook
Push the pin
firmly until
it stops.
FALL, GET UP AND FALL AGAIN
TUMBLING
ROBOT
LET'S PLAY
WITH "CO-BOT"!
AMAZING AND
AMUSING WALK!
4
5
JR. SCIENTIS
T
TUMBLING ROBO
T