East Coast Supercharging ECS Trans Strut Brace - Manual (Page 5)

21.Install the 2 supplied
3/8 24 x 1 ½” bolts
into the top front
holes in each differen-
tial bracket. Be sure
the bolts face in to-
wards the center of
the rear. (fig. 6)
22.Holding the rear rod
end with your fingers,
spin the counter
clockwise until the
ball end goes onto the
3/8 bolt. (fig. 6)
23.Once both top rods
are connected install the supplied 3/8 24 locknuts. Tighten all 4 bolts attaching
the top rods.
24.Install the 2 short lower rods onto the front transmission brackets using the
supplied 3/8 24 x 1” bolts and lock washers. Be sure the knurled end is to-
wards the rear. (fig 7)
25.Install the 3/8 x 1 ¾ “ bolt into the welded spacer on the right side diff plate.
Be sure the bolt faces inward towards the rear.
26.Install the 3/8 x 1 ½”
bolt into the left side
diff plate. Be sure the
bolt faces outward away
from center.
27.Holding the rear rod
ends spin the rods
Counter clockwise until
the rod ends attach to
the 3/8 bolts. The left
side lower strut rod at-
taches onto the outside
of the differential
bracket unlike the other
three rods.
Fig 6
Fig 7