East Coast Supercharging ECS Trans Strut Brace - Manual (Page 4)

11.Install the left side trans-
mission bracket with the
supplied 10mm x 55mm
bolts and torque to 45 ft.
lbs. (fig. 4)
12.Remove lower 2 right
side transmission bolts.
13.Install the right side
transmission bracket with
the supplied 10mm x
55mm bolts and torque to
45 ft lbs
14.Unpack the 8 rod ends
keeping the left and right
hand ends separate.
15.Unpack the 3/8 jam nuts. The jam nuts with the line in the center of the hex
are the left handed ones.
16. Screw the jam nuts onto the threaded portion of the rod ends all the way to
the ball end.
17.Keep the left hand and right hand rod ends separate to ease future installa-
tion.
18.Locate the 4 strut bars and take notice that the bars have a knurled end on
one side. The knurled end is the left handed thread.
19.Apply some anti-seize
onto the threads of the
rod ends and screw
them into the rods un-
til they bottom out.
20.Attach the two longer
bars onto the top
transmission bracket
using the supplied 3/8
24 x 1” bolts and lock
washer. Position the
rods so that the
knurled or L/H end is
towards the rear.
(fig. 5)
Fig 4
Fig 5