EarthQuake 60005072 - Manual (Page 17)

Operator's Manual
Viper Engine, 159cc
Check for parts online at www.ardisam.com or call 800-345-6007 M-F 8-5
17
AIR cleAneR
Remove the air cleaner cover and inspect the filter.
Clean or replace dirty filter elements. Always replace
damaged filter elements. If equipped with an oil-bath air
cleaner, also check the oil level.
Inspection
1. Press the latch tabs on the air cleaner cover or remove
the cap nuts, and remove the cover. Check the filter
to be sure it is clean and in good condition.
2. Reinstall the filter and air cleaner cover.
cleaning
1. Tap the filter several times on a hard surface to
remove dirt, or blow compressed air (not exceeding
30 psi [207kPa, 2.1kg/cm²]) through the filter from the
clean side that faces the engine. Never try to brush off
dirt. Brushing will force dirt into the fibers.
2. Tap the filter outer several times on a hard surface
to remove dirt. Clean. If the outer filter is very dirty,
replace it.
3. Wipe dirt from the air cleaner body and cover using a
moist rag. Be careful to prevent dirt from entering the
air duct that leads to the carburetor.
CAUTION
oPeRATInG THe enGIne WITHouT An AIR
fIlTeR, oR WITH A dAMAGed AIR fIlTeR,
WIll AlloW dIRT To enTeR THe enGIne,
cAusInG RAPId enGIne WeAR. THIs TYPe of
dAMAGe Is noT coVeRed bY THe dIsTRIbu-
ToR’s lIMITed WARRAnTY.
Figure 22: Cleaning the foam filter element
AIR CLEANER bODY
FILTER
OUTER FILTER
LATCH TAbS
AIR CLEANER
COvER
FILTER
CAp NUT