Ditch Witch SK850 Footings Machine - Manual (Page 99)

Specifications - 98
SK850 Operator’s Manual
SK850 Basic Unit
CMW
®
Specifications are called out according to SAE recommended practices. Specifications are general and subject to change without
notice. If exact measurements are required, equipment should be weighed and measured. Due to selected options, delivered
equipment may not necessarily match that shown.
Bucket rollback angle, ground level 25° 25°
Bucket rollback angle, full height 90° 90°
Dump angle, standard bucket at max dump height 35° 35°
Bucket width, max 44 in 1120 mm
Bucket width, min 36 in 915 mm
Swing radius, max, with standard bucket 65 in 1650 mm
Swing radius, no attachment 44 in 1120 mm
Rear overhang, max 29 in 735 mm
Performance U.S. Metric
Ground drive speed, forward and reverse 4.7 mph 7.6 km/h
Ground pressure, 7” (180 mm) tracks * 5.5 psi 0.38 bar
Ground pressure, 9” (230 mm) tracks * 4.5 psi 0.31 bar
Tipping capacity
The rated operating capacity for this machine was determined using a standard bucket in
the drive position with center of gravity 7 in (18 cm) from the mounting plate. Depending
on the attachment, the actual operating capacity of the attachment may vary.
2465 lb 1118 kg
Operating capacity (35% of tipping capacity) 860 lb 390 kg
Machine weight (fluids full) 3100 lb 1406 kg
* Includes machine weight, 175-lb (80-kg) bucket, 165-lb (75-kg) operator
Battery
SAE reserve capacity 110 min, SAE cold crank @ 0°F (-18°C) 800 amp, 12V electrical system
Fluid Capacities U.S. Metric
Fuel tank 10.5 gal 40 L
Engine oil, with filter 5.0 qt 4.7 L
Hydraulic reservoir 9.2 gal 35 L
Coolant capacity 1.28 gal 4.8 L
Dimensions U.S. Metric