Dillon Precision Case Preparation Tools - Manual (Page 3)

For expert assistance or to place an order, call (800) 223-4570
Dillon Large & Small
Case/Media Separator
Dillon’s small and large case/media separators.
Large Separator, #20675
Small Separator,
#21045
TO ASSEMBLE: Open the blue separator basket by pulling the spring
loaded latch(es).
Using the 1-1/4” bolts, fasten the crank handle across the bottom half
of the basket (the half without the latches). Be certain the crank handle is
in the down position. (See above photo.) It may be necessary to spread
the basket slightly to line up the handle bolt holes.
SPECIAL NOTE FOR THE LARGE SEPARATOR ONLY: Using the 5/8”
bolts, hang the two steel brackets on the inside of the tub. Be sure the
two curved fingers on the bracket wrap over the edge of the tub. Washers
and nuts must be assembled on the outside of the tub. Place the
basket/handle assembly across the brackets.
TO OPERATE: Be certain the roll pin (on the end of the crank handle)
is positioned in the bracket to keep the basket from turning. Then open
the basket.
Pour cases and media directly from the case cleaner into the open bas-
ket. Close the basket and secure the latch(es). Move the roll pin out of the
bracket so the basket has free motion. Rotate the basket by turning the
crank handle several times. The media is collected in the tub for future use
and the basket is now full of clean cases. We suggest transferring the media
to a sealed container to keep it dry for the next cleaning session.
1
Accessory Manual, May 2007 5/22/07 8:27 AM Page 4