DICE Electronics DICE interface for iPod Volkswagen - Manual (Page 16)

5c - Cable modification - If vehicle is equipped with factory Satellite radio and desired to be retained, a harness
modification is required.
10
SAT
connector
1 Disconnect main radio
harness and locate SAT
connector. Remove it from
main harness by pressing on
the release tab of the SAT
connector.
2 Slide out the inner part of the
SAT connector from plastic
housing.
3 Disassemble the VW-R2
connector the same way as
the factory SAT connector.
4 Remove the SAT wires from
the factory connector by
releasing the pins with a
small screw driver or ball-
point pen.
5 Relocate wires to VW-R2
connector keeping the same
order and location.
6 Put plastic connector covers
back on. Insert VW-R2
connector to factory VW main
harness.
7 Connect ground wire to
chassis of radio.
10
VW-R2
connector
pins 1, 3, 7
pins 1, 3, 7
16