DaySequerra M2.0X - Manual (Page 6)

6
M2 User Manual
Unpacking and Installing the M2
Immediately upon receiving your M2, please make a careful inspection for any shipping damage. If
damage is found or suspected, please notify the carrier at once and then contact your dealer. The
DaySequerra M2 is shipped in one carton, which contains: the M2 unit, an AC power cable, a Torx
TM
T-8 L-key and this User Manual.
We strongly encourage you to save the shipping carton and shipping materials supplied with your M2.
They are specially designed to properly protect your M2, and in the event that you need to return it for
service, only these OEM shipping materials can ensure its safe return to our factory.
We provide a limited 1-year warranty on all of our products, but if you don’t register your unit, it’s hard
for us to contact you when software updates become available. So please take a few minutes to
complete the warranty registration form on our web site, www.daysequerra.com. Thank you!
Rack Mount Installation. The M2 chassis has four rack mounting holes in its chassis and has been
designed to fit in a 19” standard 1RU space. Plastic ‘finishing’ washers are recommended to protect
the painted finish around the mounting holes.
Power Connection. The AC power cable supplied with the M2 must be connected from the M2’s
IEC320 power entry module to an AC mains outlet with a functional earth ground connection. The M2
has been set at the factory to operate at 120VAC unless otherwise specified on the shipping carton.
Please connect your M2 to an uninterruptible power supply (UPS) to protect against power
surges and brownouts.
Antenna Input Connections. Separate 75ohm F-type connectors are provided on the M2 rear panel
for dedicated AM and FM antennas. Rear panel switch selects for antenna or high-level (7VP-P) inputs.
Audio Output Connections. Analog audio left and right outputs are on rear-panel XLR connectors
with pin 1 GND, pin 2 + and pin 3 -. The digital audio output is transformer-isolated in S/PDIF format on
a rear-panel XLR connector with pin 1 GND, pin 2 XFMR and pin 3 XFMR. The M2 digital audio output
is 5.1 surround capable.
Front Panel Controls and Indicators
TUNER BAND – Selects manual AM and FM tuning with UP and DN controls. Blue arrow LED
illuminates when mode is active. See below for multicast tuning.
PRESETS – The M2 has capability to recall 20 preset or stored AM stations and 20 preset or stored FM
stations. Blue arrow LED illuminates when monitor is in PRESETS mode. UP and DN controls scroll
through stored stations. When in PRESETS mode, second push of PRESETS switch changes tuner
band.
UP and DN – For manual AM and FM tuning in TUNER BAND mode and scrolling through PRESETS
in PRESETS mode.
SELECT – Multi-function switch for storing PRESETS and controlling other monitor functions, as
described below.