Cino A770 HC - Manual (Page 65)

F
u
z
z
y
S
c
a
n
P
ro
g
ra
m
m
in
g
M
a
n
u
a
l
Configure Your FuzzyScan
58
PROGRAM
Operation Control
(A Series)
♦ ♦ ♦ ♦
Aiming Control, Delay Aiming & Decode Aiming Control
♦ ♦ ♦ ♦ F_DEFAULT
Family Code Selection P.C Parameter Selection Option Code
Aiming Control SS
SS
SS Regular Aiming
Intelligent Aiming
Delay Aiming Control
0
1
2
Delay Aiming Time-out Control
SS
SS
SS
SS
SS
SS
SS
SS 200 ms
400 ms
800 ms
1 sec
1.5 secs.
2 secs.
3 secs.
4 secs. 0
1
2
3
4
5
6
7
Decode Aiming Control
SS
SS
SS
SS Disable in Hand-Held mode
Enable in Hand-Held mode
Disable in Hand-Free mode
Enable in Hand-Free mode 0
1
2
3
The Aiming Control is only available for trigger mode. In Intelligent Aiming, the aiming light is turned on when the scanner is lifted. A trigger pull activates decoding process.
After 2 seconds of inactivity, the aiming light will be shut off. Delay Aiming Control allows a delay time for the operator to aim the scanner before the image is taken. During
the delay time, the aiming light will be on, but the LED illumination won’t be turned on until the delay time is up.
The Delay Aiming Time-out Control is only available for trigger mode. You can use Delay Aiming Time-out Control to set the delay time.