DENSO CORPORATION MOVINCOOL OFFICE PRO 24 - Manual (Page 6)

GENERAL WARNINGS & CAUTIONS
1) All electrical work, if necessary, should only be performed by
qualified electrical personnel. Repair to electrical components
by non-certified technicians may result in personal injury
and/or damage to the unit. All electrical components replaced
must be genuine MovinCool parts, purchased from an
authorized reseller.
2) The proper electrical outlet for MovinCool units must be
equipped with a UL approved circuit breaker.
3) Because of potential safety hazards under a certain condition,
we strongly recommend against the use of an extension cord.
However, if you still elect to use an extension cord, it is
absolutely necessary that it will be a UL listed, 3-wire grounding
type appliance extension cord, having a 3-blade grounding plug
and a 3-slot receptacle that will plug into the appliance.
The marked rating of the extension cord should be 115 V, 15A
for Office Pro 12, and 115V, 20A for Office Pro 18 and 230V, 20A
for Office Pro 24 or equivalent.
4) The Office Pro 12 and Office Pro 18 are equipped with a ten (10)
foot (3 meter) UL approved LCDI power cords. The Office Pro 24
is equipped with a six (6) foot (1.8 meter) UL approved LCDI
power cord. If replacement, fixed location (hard wired) or
power cord lengthening (extension cord) cords are required,
contact your reseller or a qualified electrician for approved
replacement methods.
5) Never fold or place heavy objects on the power cord.
This could result in damage to the power cord causing
electrical shock or fire.
6) Do not place water or any other liquid on the unit. This can
cause damage to the unit and increase the risk of electrical
shock.
7) Do not sit or stand on the unit.
6