DENSO CORPORATION MOVINCOOL OFFICE PRO 24 - Manual (Page 16)

16
3) Press ENTER button to set Hour.
5) Press ENTER button to set Minute.
NOTE: User should check clock periodically to confirm clock accuracy.
Operating in COOL Mode
Operating in Fan Only Mode
Changing from Fan Only Mode to COOL Mode
OPERATION (cont.)
Prior to operating the Office Pro 12, 18, or 24 users should set the clock
of the controller to the correct time as shown in the following steps :
1) Press and hold the SET CLOCK
button for 3 seconds or until beep.
(LCD will indicate blinking “CLOCK”
and blinking “Day of the week ”)
2) Press SET TEMP buttons to
select day of the week.
4) Press SET TEMP buttons to select
desired hour.
6) Press SET TEMP buttons to select
desired minute. Press SET CLOCK
button to exit set clock mode.
1) The unit can be operated in COOL mode by pressing the COOL
ON/OFF button (LCD indicates COOL ON).
NOTE : In COOL mode the unit can only be turned off by pressing
the COOL ON/OFF button again, not by pressing the fan buttons.
2) Change the fan speed by pressing the fan HI/LO button.
3) Change the temperature set point by pressing the SET TEMP
buttons ( / ).
NOTE : When turning the unit on, the set point and fan speed are
determined by the last operating mode.
(program mode not included).
NOTE : The Fan Only mode will not operate after the COOL mode
has been activated. After the COOL mode has been activated, the
unit cannot be turned off by pressing the fan buttons. The COOL
ON/OFF button must be pressed.
The COOL mode can be activated while the unit is operating in Fan
Only mode. To do this, simply press the COOL ON/OFF button
(LCD indicates COOL ON).
2) The unit can then be turned off by pressing the fan HI/LO button
until fan turn off (Fan only mode speed sequence are HI
→LO→OFF)
1) The unit can also be operated in Fan Only mode by pressing fan
HI/LO button (LCD indicates FAN HI/LO and COOL OFF).
Step 1 & 6
Step 2 to 5
MO TU WE TH FR SA SU
START
STOP
CLOCK
FAN
COOL
PROGRAM
ON
LOCKED
SET TEMP
HI
LO
ON
OFF ROOM TEMP
AM
PM
F F
FAN MODE
HI/LO
ON/OFF
COOL MODE SET TEMP
TANK FULL
PROGRAM
RUN/
STOP
SET
PROG
SET
CLOCK
ENTER
PROGRAMMING
Set Clock
C C