DENSO CORPORATION MOVINCOOL OFFICE PRO 24 - Manual (Page 25)

Check the following items before calling a qualified technician
SYMPTOM
Unit does not operate
Insufficient Cooling
POSSIBLE CAUSE REMEDY
1) Ground fault breaker
trip or LCDI power
cord trip.
2) Drain Tank is full
(Tank Full LED
will be flashing)
3) High Pressure Activated
10 times in 24hours.
1) Dirty/Blocked air filters
2) Air Inlet/Outlet blocked
3) Improper temperature setting
Reset Breaker or Reset
power cold
Empty the drain tank
1) Clean air filter.
2) Check inlet and outlet air,
and make sure that there
were not any object that
may prevent air flow into
or out from the unit.
3) Check environmental
condition whether it is
within operation range
or not.
4) Reset controller
Clean air filter
Clean air inlet/outlet
Adjust temperature setting
If symptoms persist after the above actions have been taken,
turn the unit off, disconnect the power cord plug and contact
your MovinCool reseller.
TROUBLESHOOTING
25