DENSO CORPORATION MOVINCOOL OFFICE PRO 24 - Manual (Page 10)

!
WARNING:
! CAUTION:
:
INSTALLATION (cont.)
Plugging in the
Unit
1) Check the prong and surface of the power cord plug for
dust/dirt. If dust and/or dirt are present, wipe off with a clean,
dry cloth.
2) Check the power cord, plug and prong for damage or excess
play. If any damage or excess play is found, contact your
MovinCool reseller for repair.
1) If the power cord or plug is damaged, repair should only be
performed by qualified electrical personnel.
2) Do not connect/disconnect the power cord or attempt to
operate buttons with wet hands. This could result in
electrical shock.
1) Office Pro 12 model ONLY : The AC outlet (115 VAC Single
Phase, 60Hz) needs to be rated at 15A or higher. Do not share
the outlet with any other instrument or equipment.
2) Office Pro 18 model ONLY : The AC outlet (115 VAC single
Phase, 60Hz) needs to be rated at 20A or higher. Do not share
the outlet with any other instrument or equipment.
3) Office Pro 24 model ONLY : The AC outlet (208/230 VAC single
phase, 60Hz) needs to be rated at 20A or higher. Do not share
the outlet with any other instrument or equipment.
NOTE :
1) Make sure the AC outlet is free of dirt, dust, oil, or any other
foreign matter.
2) The Office Pro 12 model is equipped with a UL approved LCDI
cord and an approved NEMA p
lug configuration (5-15).
The appropriate outlet must be used for this plug type.
3) The Office Pro 18 model is equipped with a UL approved LCDI
cord and an approved NEMA p
lug configuration (5-20).
The appropriate outlet must be used for this plug type.
4) The Office Pro 24 model is equipped with a UL approved LCDI
cord and an approved NEMA plug configuration(6-20).
The appropriate outlet must be used for this plug type.
10