Avalue EPI-QM87R - Manual (Page 37)

User’s Manual
EPI-QM87R/ EPI-QM87 User ’s Manual 37
3.1 Introduction
The BIOS setup program allows users to modify the basic system configuration. In this
following chapter will describe how to access the BIOS setup program and the
configuration options that may be changed.
3.2 Starting Setup
The AMI BIOS™ is immediately activated when you first power on the computer. The BIOS
reads the system information contained in the NVRAM and begins the process of checking
out the system and configuring it. When it finishes, the BIOS will seek an operating system
on one of the disks and then launch and turn control over to the operating system.
While the BIOS is in control, the Setup program can be activated in one of two ways:
By pressing or immediately after switching the system on, or
By pressing the or key when the following message appears briefly at the
bottom of the screen during the POST (Power On Self Test).
Press or to enter SETUP
If the message disappears before you respond and you still wish to enter Setup, restart the
system to try again by turning it OFF then ON or pressing the "RESET" button on the
system case. You may also restart by simultaneously pressing , , and
keys. Remove all storage can also enter the BIOS Setup Utility.