Angelcare AC1100 User Manual

Page 8

STEP 4 - TURNING ON YOUR MONITOR

1) Press the Parent Unit ON/OFF button

for 2 seconds until blue screen appears.

2) The Parent Unit will display

Video mode screen.

3) Press the Menu icon to access

main menu.

4) The Parent Unit will display

Menu mode.

5) Push and hold the Nursery Unit left

‘wing’ button for 2 seconds.

Temperature icon:
Indicates room temperature

Temperature Alarm icon: Indicates
Temperature Alarm is active

Pendulum icon: Indicates the
Motion Sensor is active

Sound icon: Indicates that Sound
function is active

Alarm icon: Indicates selected
alarm mode

Sound alarm

and vibration

Vibration only

INDICATION BAR IMPORTANT ICONS

Connection icon: Indicates the
connection quality between the
Parent Unit and Nursery Unit.

Good connection

Poor connection

Lost connection

Out-of-Range

Battery Level icon:

Indicates battery level

Empty

1/3 Full

2/3 Full

Full

When Parent Unit is turned ON and
Nursery Unit is OFF, Parent Unit will
display Disconnected Mode and will
turn itself OFF after 60 seconds.

If there is a lost connection
between the 2 units (refer to
troubleshooting):

• The Out-of-Range icon will

appear on the screen.

• The Lost Connection icon will

appear on the indicator bar.

5.1 - SENSOR PAD

1) Press Menu icon to access

main menu.

2) Press Movement icon to activate

deactivate Movement Alarm.

3) Press OK icon to confirm.

1) Move your hand lightly on the mattress.

The pendulum icon will appear

on Parent Unit indicator bar.

It will move as you move your

hand and trigger a ‘TIC’ sound.

2) Remove your hand from the mattress.

After 15 seconds you will hear a
‘TIC’ pre-alarm sound, and 5 seconds
later the Movement Alarm will trigger.

IF THE ALARM DOES NOT SOUND

• Avoid contact with crib while Sensor Pad is in operation.
• Place crib near a supporting wall.
• Turn OFF crib mobile, fans, loud music or anything else that may cause vibration.
• Adjust Sensor Pad sensitivity level.

OFF

TO ACTIVATE THE SENSOR PAD:

TO TEST THE SENSOR PAD:

MOTION ALARM

• Alarm activates when no movement is detected by Sensor Pad for 20 seconds.

• Both the Parent Unit and Nursery Unit speakers will emit loud warning sound.

• Motion Alarm icon will show on the LCD screen.

STEP 5 - TESTING AND GETTING TO KNOW YOUR MONITOR

IMPORTANT
When in menu or sub-menu modes,
sound transmission between Parent
and Nursery Units will be temporarily
deactivated. ONLY movement-
detection alarm will remain active (if
function is activated).

All changes and
adjustments made
in the main menu and
sub-menus will not be
activated unless you
confirm them by pressing
the

OK icon.

The Angelcare

monitor can be used with the pre-program factory settings or you can

also customise your settings to your preference.