AMT Datasouth Fastmark PT-1 - Manual (Page 4)

4
Fastmark PT1 User ’s Guide
Proprietary Statement
This manual contains proprietary information of AMT Datasouth Corporation. It is intended solely for
the information and use of parties operating and maintaining the equipment described herein. Such
proprietary information may not be used, reproduced, or disclosed to any other parties for any other
purpose without the expressed written permission of AMT Datasouth Corporation.
Product Improvements
Continuous improvement of products is a policy of AMT Datasouth Corporation. All specifications and
signs are subject to change without notice.
FCC Compliance Statement
This equipment has been tested and found to comply with the limits for a Class A digital device,
pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection
against harmful interference in a residential installation. This equipment generates, uses, and can
radiate radio frequency energy and, if not installed and used in accordance with the instructions, may
cause harmful interference to radio communications. However, there is no guarantee that the
interference will not occur in a particular installation. If this equipment does cause harmful interference
to radio or television reception, which can be determined by turning the equipment off and on, the user
is encouraged to try to correct the interference by the following measures:
 Reorient or relocate the receiving antenna.
 Increase the separation between the equipment and the receiver.
 Connect the equipment into a different outlet on a different circuit.
 Consult the dealer or an experienced Radio/TV technician for help.
This unit was tested with shielded cables on the peripheral devices. Shielded cables must be used with
the unit to insure compliance. The user is cautioned that any changes or modifications not expressly
approved by AMT Datasouth Corporation could void the user’s authority to operate the equipment.
Liability Disclaimer
AMT Datasouth Corporation takes
steps to assure that the company’s published engineering
specifications and manuals are correct; however, errors do occur. AMT Datasouth Corporation
reserves the right to correct any such errors and disclaims any resulting liability. In no event shall AMT
Datasouth Corporation, or anyone else involved in the creation, production, or delivery of the
accompanying product (including hardware and software) be liable for any damages whatsoever
(including, without limitation, damages for loss of business profits, business interruption, loss of
business information, or other pecuniary loss) arising out of the use of or the results of use of or
inability to use such product, even if AMT Datasouth Corporation has been advised of the possibility of
such damages.
RF exposure warning
·
The equipment complies with FCC RF exposure limits set forth for an uncontrolled environment.
The equipment must not be co-located or operated in conjunction with any other antenna or transmitter.
CAUTION:
Any changes or modifications not expressly approved by the party responsible for compliance could
void the user's authority to operate the equipment.