AMT Datasouth Fastmark PT-1 - Manual (Page 25)

25
Fastmark PT1 User ’s Guide
Status Blinking LED
MEMORY FULL POWER LED blinking
Possible Symptoms & Solutions
The printer memory buffer is fully loaded with downloadable soft
fonts, graphics or forms.
Check the format and size of stored data with available memory
size or call for service.
Status Blinking LED
Print Head overheated POWER LED blinking
Possible Symptoms & Solutions
Printer enters PAUSE status to wait for print head to cool down;
printer will resume printing tasks when it is ready.
Performing Calibration
If labels with gaps/black marks are in use, perform media calibration before printing to make
printer index correctly.
1. Verify the Printer Power is off.
2. Properly install labels.
3. Press and hold the FEED button then turn on power; do not release the button until printer
starts to feed labels.
4. Then, press FEED button once or twice to check that labels are correctly indexed.
Note: You must always carry out calibration when changing
media. Failure to do so will result in improper
detection by the label sensor.