Alwarerc Streak 800 Hexacopter Combo - Manual (Page 22)

6.7 Assembly Steps – Bipod Landing Gear.
Step 1.
Insert the Landing Gear Skid into the mounting
hole of Carbon Fiber Leading Gear Assembly.
(Tips: You can rotate the Landing Gear Skid into
the hole with less effort.) Step 2.
Adjust the length of the Landing Gear Skid. Each
side of the Landing Gear Skid should be about
195mm.
Step 3.
Secure Landing Gear Skid onto the Carbon Fiber
Leading Gear Assembly using the M3 Set Screw
which is pre-installed on the Landing Gear Skid
Metal Mount. Step 4.
Repeat Step 1-3 to complete another side of Bipod
Landing Gear Assembly. (Remarks: Two set of
Bipod Landing Gear Assemblies are not exactly the
same but is in symmetry direction.)
22