Alwarerc Streak 800 Hexacopter Combo - Manual (Page 10)

5. Soldering Job
Solder 2 pairs Battery Cable to the Large Current
Power/ESC Board and connect the other end to the
Battery Connectors. (Red = +ve , Black = -ve)
Do not
short circuit two polarities!
1.) Solder Black and Red AWG wires to the ESC.
2.)Solder 3pcs 3.5mm Bullet Connectors (Female) to
the ESC.
3.)Connect Servo Extension Wire to the Signal
Connector of ESC and secure it using Adhesive Tape.
Solder the AWG wires (which is connected to the
ESC) to the Large Current Power/ESC Board after
installed to the Motor Mount
(Please refer to page 19 ).
10