8 cfast port, 7 rear panel i/o connectors, Cfast port – ADLINK MXE-5400 User Manual
Page 27: Rear panel i/o connectors, Table 1-7, Mxe-5400 rear panel i/o connector legend, Figure 1-8, Rear panel i/o, Preliminary

PRELIMINARY
Introduction
15
MXE-5400
USB flash, USB external HDD, and USB CD-ROM drivers and
boot priority and boot device configured in BIOS.
1.6.8
CFast Port
A type II push-push CFast host connector on the front panel con-
nects to the host controller by SATA interface, with data transfer
rates up to 3.0Gb/s(300MB/s)/1.5Gb/s(150MB/s) supported.
1.7
Rear Panel I/O Connectors
This section describes I/O connectors located on the rear panel of
the MXE-5400.
Figure 1-8: Rear Panel I/O
Table 1-7: MXE-5400 Rear Panel I/O Connector Legend
NOTE:
NOTE:
X
When using USB CD-ROM via USB 3.0 port to
re-install or repair the OS, cold boot should be
utilized
X
Four USB 3.0 ports support additional current up
to 1600mA, positioned as shown in Table 1-1 on
page 8
A
Antenna connection plugs
(X4)
D
eSATA connector
B
DB-62P COM ports and digital
I/O connector
E
I210 Gigabit Ethernet ports
(X2)
C
Audio jacks
F
DC power supply connector
A
B
C
D
E
F