ADLINK Starter Kit - nanoX - Manual (Page 25)

If you not using a DVI monitor with the ADD2 DVI card, skip ahead to
Section 2.5, LVDS
Output using HannStar Flat Panel Display.
Install SDVO flat cable onto carrier board (if required) Required items
Step 6
Lift the locking mechanism on the nanoX-BASE SDVO
input connector (CN30) and insert the SDVO flat cable.
Insert the SDVO flat cable into nanoX-BASE SDVO input
connector and press down on the locking mechanism
Repeat for the SDVO output connector (CNX5).
NanoX Starter Kit – Quick Start Guide Page 25