ADLINK cPCIS-1100A Series - Manual (Page 40)

36 • Power Supply Unit
• Dielectric Withstand: Meets IEC950 regulation
• EMI: Meets EN55022 / FCC Class A
• Hold-up Time: 5mS after power fail signal
• Remote ON/OFF: Available at [INH#] & [EN#] pins
• Power Fail Signal: Available at [FAL#] pin
• Status LED: means valid input voltage; means a
critical fault.
• Thermal Protection (OTP): Installed NTC and thermostat for thermal
sensor at [DEG#] pin
• Power OK: Installed at all outputs
• Leakage Current: Typ. 0.5mA
Output Characteristics
Output Current (A)
Output
Voltage
MIN. MAX. TYP. PEAK.
5V
MAIN +VO1
@ ★ # ≡ ⊙
2.0 33.0 25.0 –
3.3V
AUX. +VO2
▲ @ ★ # ≡ ⊙
0 33 18 –
12V
AUX. +VO3
▲ ≡ # ⊙ ★ @
0 5.5 5.5 6
-12V
AUX. –VO4
● ⊙ ★ ■ =
0 1 0.5 1.5
Symbol: "★" OVP built-in; "@" Adjustable; "#" Remote sensing;
"≡" 3rd-wire Load Sharing; "=" Droop Current Sharing;
"⊙" Installed with Or-ing diode; "▲" Magnetic Amplifier;
"●" Installed with Post-regulator; "■" Common Choke.
Remarks: Peak load sustainable for less than 60sec. with duty cycle <10%.
Max. load is the continuous operating load of each rail. Max. load
of each rail cannot be drawn from all outputs at the same time.