ADLINK cPCIS-1100A Series - Manual (Page 13)

Getting Started • 9
The installation and removal procedures for a RTM are the same as those for
CompactPCI boards. Because they are shorter than front boards, pay careful
attention when inserting or removing RTMs. Only models with an “R” at the end
of the model number support RTMs.
Note: We strongly recommended the use of RTMs with AB type connectors
to prevent damaging the backplane during RTM installation.
2.4 Powering Up the System
Connect the supplied power cord to the socket on the back of the chassis. All
supplied PSUs are full range 90-240VAC and do not require input voltage
setting.