ADLINK CT-61 - Manual (Page 39)

Getting Started 29
CT-61
5 Getting Started
This chapter describes the installation of the following components
to the CT-61.
X CT-61 Blade installation
X PMC/XMC module installation
5.1 CT-61 Blade Installation
1. Carefully align the edges of the blade with the edges of
the slot.
2. Check that all the wedge locks lie flat against the board.
3. Slide the blade into the slot.
4. Tighten the wedge locks using a hex torque screwdriver
set to 6.0 ±0.5 kgf·cm (0.59 ±0.05 N·m).
To remove the conduction-cooled blade, use the following steps:
1. Loosen the wedge locks using a hex screwdriver.
2. Use the ejection levers to disengage the lock.
3. Carefully remove the blade from the conduction-cooled
chassis.