Pre-installation preparation, Stove and burner system assembly, Continued – Desa CSDPBN User Manual
Page 5: Unpacking stove, Stove back stove top
111739-01A
For more information, visit www.desatech.com
For more information, visit www.desatech.com
5
5
6
"
(15.24 cm)
4
"
(10.16 cm
Front
4"
(10.16 cm)
from
Front
Ceiling
Floor
from
Back
Wall
29"
(73.66 cm)
42"
(106.68 cm)
36"
(91.44 cm)
4"
4"
(10.16
cm)
(10.16
cm)
Figure 3 - Clearances for Standard Installation
Figure 4 - Clearance for Corner Installation
Figure 5 - Stove With Burner System Bottom Dimensions
Front
3.
Proper clearances must be maintained, see Figures 3 and 4.
4.
This stove is a freestanding unit designed to set directly on the
floor. If your stove is to be installed directly on carpeting, vi-
nyl tile, or any combustible material other than wood, it must
be installed on a metal or wood panel extending the full width
and depth of the stove. See Figure 5.
PRE-INSTALLATION
PREPARATION
Continued
STOVE AND BURNER
SYSTEM ASSEMBLY
UNPACKING STOVE
1.
Lift off corrugated box enclosing stove body crating.
2.
Remove screws fastening back and top of wood frame enclo-
sure. Two or more people must carefully lift stove up and out
of wooden crate.
3.
Remove plastic bag from stove body.
4.
Remove bubble-wrapped log set from stove (Doors must be re-
moved to do this step. See Removing/Replacing Doors and Glass,
page 6). Remove all protective packaging applied for shipment.
5.
Check all items for any shipping damage. If damaged, promptly
inform dealer where you bought heater. Some fiber flakes may
fall from logs. This is acceptable.
6.
Locate the product identification label on the back panel (see
Figure 6) and record the model number and 7 digit serial num-
ber in the space provided in the back of this owner’s manual,
and on the owner's registration form, page 39. Retain this opera-
tion and installation manual for future reference and warranty.
7.
Place freestanding stove near desired location in room.
Product
Identification
Label
PRE-INSTALLATION PREPARATION
Location and Space Requirements (Cont.)
STOVE AND BURNER SYSTEM ASSEMBLY
Unpacking Stove
27"
(68.58 cm)
26
1
/
2
"
(67.31 cm)
19"
(48.26 cm)
Figure 4 - Unpacking Stove from Wooden Shipping Enclosure
Back of Wood
Frame
Enclosure
STOVE
BACK
STOVE
TOP
Top of
Wood
Frame
Enclosure