ADLINK ND-6021 - Manual (Page 39)

Command Set • 33
3.10 Analog Data Output
@Description
Send a value to analog output module at specified address. The data
format of the value can be engineering unit, percent, or hexdecimal value,
which is set by configuration setting command.
(ND-6024 only supports engineering format.)
@Syntax
#(Addr)(OutData) (6021 Only)
#(Addr)(Port)(OutData) (6024 Only)
# Command leading code. (1-character)
(Addr) Address ID. (2-character)
(Port) A, B, C or D
(OutData)
Value of the analog output signal,. The unit of the
value can be engineering units, % of FSR, or
hexadecimal value. Refers to chapter 4 for details of
the data format.
@Response
or
?(Addr)
> Command is valid.
?
Command is invalid or no synchronized sampling
command was issued.
(Addr) Address ID.
@Examples
User command: #0616.000
Response: >
The command sets the analog output to be 16 mA at address 06H, if the
data format is configured as engineering units and 0~20mA output range.
User command: #08+020.00
Response: >