Autostart AS-6265iSH - Manual (Page 4)

Remote-Starting
Press the start button for approx. 1 second. The parking lights will come on , informing
you that the unit has received your signal. The engine will start approx. 5 seconds later.
The parking lights will remain on during the pre-programmed run time.
If the vehicle doesn’t start at the first attempt, the system will shut down. If your vehicle is
equipped with an automatic transmission, there will be 3 start attempts before the system
gives up.
Vehicle Presets
Heater & Heated Seat
When leaving the vehicle it is recommended to preset the accessory controls in
preparation for the next remote start. Settings for the blower motor (fan), front and rear,
as well as heated seats (if equipped) should not be left on high . It is recommended to
leave the settings on low or medium instead.
Windshield Wipers & Radio & Headlights
Certain vehicles require the radio and / or windshield wiper and / or headlight circuits to
become energized while running under remote start. When leaving the vehicle you must
ensure that the windshield wiper and headlight switches are off . Leaving the headlight
switch on on certain vehicles could cause them to remain on even after remote starter
shut down, resulting in a dead battery.
Driving Off
With the vehicle running under remote control, press the unlock button to disarm and
unlock the doors. Enter the vehicle and do the following:
Turn the ignition key to the ignition on ( run ) position. (Do not turn the key to the Start
position while the engine is running. This will cause the starter motor to re-engage.)
Press the brakes to disengage the remote starter unit.
You are now ready to drive off.
Idle Mode
Convenience feature: Idle Mode allows you to keep the engine running and the doors
locked while you stop, for example, at a convenience store or for a short delivery.
This feature allows you to let the remote starter take over control of the vehicle (i.e. no
Key in the Ignition Switch) while the engine is running. For example, if you stop for a
delivery or at a convenience store, lock your vehicle and leave it running for the length of
a run cycle while you are away.
Idle Mode can be activated through the same routine as that used for Ready Mode; at
the last step, the trunk button is pressed instead of the other buttons:
1. Ensure that all the Doors are closed and that the Shifter is in the Neutral
position.
2. With the Engine already running, apply the Parking Brake and release the
Brake Pedal.
Make sure to release the brake pedal.
3. Within 20 sec. Push lock , unlock or start on the Transmitter.
The parking lights will flash 3 times quickly and remain lit.
4. Remove the key: the Engine will go on running.
5. Exit the vehicle and close the Door.
User Guide P. 4
Siren Chirps
(On by default.) The siren will chirp to confirm the system's basic operations:
By default, when the doors are being locked the siren will give one chirp if none of the
zones are active.
If a zone is active as the doors are being locked, the siren will give three chirps.
When the doors are being unlocked, the siren will give two chirps if no intrusion was
detected.
If an intrusion was detected, as the doors are being unlocked the siren will give four
chirps.
The system can alternatively be set to:
Warning Mode (no chirp during lock/unlock - unless a zone is active when locking, in
which case there will be 3 chirp upon locking - or unless the alarm was triggered, in
which case there will be 4 chirps when unlocking);
Open Zone Notification (the system will warn for doors opened up to 10 seconds after
arming).
No Chirp (the vehicle will not chirp under any circumstance).
Open Zone Notification:
(Off by default.) This feature will warn the user when a Door is left open: upon the
arming of the Module, a 10-sec. notification delay will take place, after which the Siren
will chirp 3 times if an open door is detected.
Ignition-Controlled Door Locks
This is an added security feature. If your system was installed with the Ignition-Controlled
Door Locks option, the doors will automatically be locked as soon as the key is turned to
the ignition on ( run ) position while the brakes are pressed. When the key us turned to the
off position, the doors will automatically be unlocked.
Ignition Re-Lock
When the Ignition-Controlled Door Locks option is enabled and the ignition is on , should
any door be unlocked and opened, all the doors will be re-locked next time the brake
pedal is pressed.
Secure Lock
This is an added security feature. If your system was installed with the Secure Lock
option, it will automatically lock your doors and arm the system 4 seconds after your start
your car by remote. The system will automatically lock the doors again after shut-down.
Remote Trunk Release
If your system was installed with the Remote Trunk Release, you can open your trunk by
pressing the trunk button for 3 sec. on the transmitter, or by pressing the trunk button
twice within 3 sec.
Starter Kill
This added security feature will immobilize your vehicle when the system is armed. If
your system was installed with the Starter Kill option, you will not be able to start your
vehicle with the key unless the system has been disarmed first.
The Starter Kill option follows the Alarm arming function, and can therefore be
programmed to be active (will not arm automatically) or passive (will arm automatically).
P. 9 User Guide